4 Speed hump placement

lilwendal · February 04, 2006, 10:28:37 PM

Anyone out there have an easy method of locating the correct position for a 4 speed hump outside of actually mounting the tranny then adjustung the hump before welding? Doing a conversion and was wondering if there is a measurement reference point I could use. Any help would be great. Thanks

Troy · February 04, 2006, 10:41:11 PM

Yes, just drop it in.

There are indentations on the floor and the hump only fits one way.

Troy

Drop Top · February 05, 2006, 01:00:11 PM

lilwendal · February 05, 2006, 08:31:50 PM

That sounds too easy.

dodgeboy67 · February 07, 2006, 04:54:02 PM

I WAS GONNA ASK THE SAME THING......THAT DOES SOUND TOO EASY.....

DAMN TROY, YOU AND DROP TOP SHOULD WRITE ONE OF THEM "CHARGERS FOR DUMMIES" BOOKS...LOL

YOU GUYS KNOW IT ALL

Troy · February 07, 2006, 07:21:34 PM

I'll take some pictures. Seriously, it's waaaayy easier than lining up the z-bar bracket...

Troy

dodgeboy67 · February 09, 2006, 11:31:41 AM

that would be great ....thanx

lilwendal · February 14, 2006, 07:00:50 PM

Thats going to be my next task, The Z bar backet. Any tips?

Troy · February 14, 2006, 11:26:33 PM

Quote from: lilwendal on February 14, 2006, 07:00:50 PM
Thats going to be my next task, The Z bar backet. Any tips?

Yep, there's a 'V' shaped notch in the frame that points right at it. I have pics somewhere but I have to dig them out. Forgive me for being slow but I've been working 12+ hours per day.

Troy

Daytona R/T SE · February 15, 2006, 12:14:36 AM

Chryco Psycho · February 15, 2006, 12:58:56 AM

there is an Oval hole in the inner fender , the bracket should center on the oval hole looking in fron the wheel well

DodgeCharger.com Forum

News: