DIRTY WHITE BOY'S 68 BUILD UPDATED 3-22-14

[cdr]

WELL today i set up my pinion depth,now i need to find an 83/4 single trac carrier.

[cdr]

[Baldwinvette77]

Stick a spool in it 

[cdr]

i have a trac lock that goes in a single trac carrier

[fy469rtse]

Good to see your upgrading drive line o cope with all that extra torque and power Charlie , Do a thread on that engine build , don't worry mine took a long time too, frustrating waiting till you can afford parts,
But I like the combination , just read through the basics to your list
it's going to be an animal

[Budnicks]

cool updates CDR, keep up the great work

[cdr]

cleaned & painted the housing

[cdr]

added some metal to the spring pads to keep them from collapsing

[cdr]

[cdr]

cleaning undercoating off.

[cdr]

thanx cranky for the springs

[cdr]

[cdr]

sliders to be installed after ride height it set.

[cdr]

[Baldwinvette77]

Nice   im pretty much doing the same stuff right now... except with a mix of a ford, chevy AND dodge parts  

[green69rt]

I gotta get over to your place and look at this stuff!!  If only the cold stays away.

[NHCharger]

Nice looking rear end Charley 

[Baldwinvette77]

Nice looking rear end Charley 

Be sure to lube those shafts up well before you slide em into that shiny black rear, if you were only inserting one, you wouldn't have to worry, but with 2 shafts, 1 in both openings, you can't be too careful  ... also good luck assembling the axle 

[charge69]

Your Charger just keeps looking better and better!  Those CalTracks actually work pretty well!  My friend that did most of the restoration on my Charger has some and, after getting them adjusted, they helped his launch quite a bit! His best results were with slicks but, his street tires hooked up better also.

[Budnicks]

  Looken' good, some much needed traction aids, will surely help...

[tan top]

     

[green69rt]

Now that the cold has gone away, I'll have to make a trip over to your place to check out the changes personally!!

[cdr]

any time.

[cdr]

my 4in diam alum drive shaft,good for over 10k rpm

[charge69]

Whoa !!  Badazz looking driveshaft!