1972 Floor Shift what am I missing? Any Pics?

[MNMopar]

I have all linkage except the bottom bracket and bushing that must come off the 727. I have a bracket with a bushing in it for the top, but what am I missing on the bottom side next to the 727?? And does anyone have one or have pics??

Thanks!

[gschmidt211]

I do believe this is the bracket you are looking for.  Sorry, I do not have an extra, but this picture may help.

[MNMopar]

that looks like what I'm missing. Looks like it attaches to the frame?

[gschmidt211]

It attaches to the the transmission.  Near the back of the transmission, where the driveshaft is inserted, there are two holes cast into the transmission housing.  They are on the bottom of the transmission.  The two studs that are mounted to the bracket I pictured go through these two holes holding the bracket in place so that when the z-bar is put through the transmission hump of the car, it engages this bracket.  So, this bracket is mounted to the transmission.  I can get pictures of that as well.  I will post it it early this week.

[John_Kunkel]

There are two different styles of that bracket, both are available from Bill Rolik and other sources.

http://www.billrolikenterprises.com/products.asp?cat=28

[charger2fast4u]

i just took off that bracket today on my charger. it's located directly under the speedometer cable port on transmission on the bottom of trans.

[MNMopar]

Usually I figure these kinda things out but this positioning is retarded! Thanks DC.com!

[71_Charger_R/T]

Hey Hey.... a fellow Minnesotan!  Here's a snap under my car.

hope it helps.

[ACUDANUT]

It attaches to the the transmission.  Near the back of the transmission, where the driveshaft is inserted, there are two holes cast into the transmission housing.  They are on the bottom of the transmission.  The two studs that are mounted to the bracket I pictured go through these two holes holding the bracket in place so that when the z-bar is put through the transmission hump of the car, it engages this bracket.  So, this bracket is mounted to the transmission.  I can get pictures of that as well.  I will post it it early this week.

Yea, what he said.

[MNMopar]

Ya sure dontchyaknow! Thanks for the pic helps me immensly, $36 for a piece of metal seems a bit steep for my budget build!

[71_Charger_R/T]

You betcha!