Exhaust tip hanger help????

[elanmars]

1/13 UPDATE-

are these the tip hangers with rubber insulators??

http://cgi.ebay.com/ebaymotors/1968-70-Mopar-Roadrunner-Conronet-Exhaust-Tip-Hangers_W0QQcmdZViewItemQQhashZitem5885701d6bQQitemZ380195839339QQptZMotorsQ5fCarQ5fTruckQ5fPartsQ5fAccessories#ht_741wt_1167

http://cgi.ebay.com/ebaymotors/68-69-70-Charger-R-t-Exhaust-tip-hangers-Pair-Mopar-RT_W0QQcmdZViewItemQQhashZitem19b6c81871QQitemZ110440749169QQptZMotorsQ5fCarQ5fTruckQ5fPartsQ5fAccessories#ht_500wt_956

-----------

My left side/driver side exhaust pipe dropped slightly towards the back, looks like it was welded in. I'm just curious if that's how the pipes go in the back, welded to the body or if they're supposed to have some kind of brace or something.

if this post is confusing, I apologize, I can post a picture!!

[Ghoste]

There are brackets welded to the underbody but between them and the point the exhaust pipe actually mounts to is a rubber insulator.  That is to say the exhaust doesn't touch steel to steel so no, it isn't welded right to the body.

[resq302]

Yup, I bet that your rubber hanger that goes where the rear of the muffler meets the over the axle pipe is broke.

[elanmars]

so I'm going to need these things here?

http://www.laysons.com/Catalog.cfm?nCatID=1279&nModelID=14&nModelYear=1969

http://www.laysons.com/Catalog.cfm?nCatID=1258&nModelID=14&nModelYear=1969

[elanmars]

and it looks like I didn't have those rubber things at ALL, as the other side is welded in to a support bracket-but looks like it's only half of one. Pics later.

[elanmars]

Ok I figured out I just need the bracket with the rubber part.