Upper Door Pad remote mirror control hole plug needed for pattern...

[xs29j8Bullitt]

My triple black car has a non-remote "poverty" mirror on the driver's side door, so has a plug installed where the remote control head normally mounts.  We need to locate a damaged donor pad with a plug that can be removed to provide a pattern for B/E & A Parts to use for their upcoming upper door pad reproduction.

The plug may be same as used on other cars from that era (like some C-Bodies), I noticed the grain pattern does not match my door pad too well...

Below are pictures for reference.

Allen

[69charger2002]

geez i have 20 pads on ebay right now.. a couple of the driver's side have the plug and are cracked up. would be perfect for that.. i stuck all the pads on ebay at once.. i'm guessing they want a nasty donor pad just shipped to them at cost right?

[Charger-Bodie]

geez i have 20 pads on ebay right now.. a couple of the driver's side have the plug and are cracked up. would be perfect for that.. i stuck all the pads on ebay at once.. i'm guessing they want a nasty donor pad just shipped to them at cost right?

Trav Im pretty sure that Mike just needs the plug.

[69charger2002]

oh well if that is the case i'll take one and off and send it
let me know where to XS29J8..  it looked to me like he needed a damaged pad and plug for the pad area to reproduce..

trav

[xs29j8Bullitt]

oh well if that is the case i'll take one and off and send it
let me know where to XS29J8..  it looked to me like he needed a damaged pad and plug for the pad area to reproduce..

trav

Thanks Trav!  I believe that Mike just needs the plug, but if it is glued in the plug would have to be cut out with damaging it (but destroying the pad).  How is it installed?

I am on my way out for dinner with friends, but will call Mike tomorrow if he doesn't chime in with his preference on the plug.

THANKS AGAIN!!! 

Allen

[JimShine]

The plug is held on with a retainer clip.

[Just 6T9 CHGR]

I still have mine....IIRC it just pops in there...it has tabs on it.

[JimShine]

That is intersting as I just removed the factory installed one from my Charger a few months ago. It had a clip holding it on like the ones used to hold the woodgrain plate to the console top plates. It was 100% factory until I messed with it.