my home made rotisserie

[Alain426]

hi gang, my 71 r/t is all disasembled, and now im in the process to built my own rotisserie to be able to work well on my car

with 4 2x2'' tubing and 2 1.75x1.75'' 12 feet long,  and 4 caster wheel, i will be able to do a simple rotisserie
you will see on the picture that the wheel are shimmed, its cause my garage is not very high (about 8') so i need to keep ym rotisserie and the car as low as possible

i will show you the result when it will be finished, maybe next week

so here where i am with it











here is the rest of the picture of the rotisserie and the charger


http://public.fotki.com/mopar/automobile/mopar_monde_automobile/charger-1/page17.html

[Charger_Fan]

Looks like it should do the trick.

[Charger1973]

Nice work.  Can I borrow it when youre done?   

[Charger-Bodie]

looking real good

[Alain426]

thanks for the comment, i cant wait to put my charger on it to see how it is, maybe this week end if i got some help

anyway, here the final pic on it, hope it will do the job:)







no, the tire doesnt touch to the metal, close, but dosent touch

[jasonfromIKILLYA]

very nice!  I want to borrow it someday too! 

[mikepmcs]

Really nice work.  Lots of talent here for sure!!!

You should make em and sell em'


v/r
Mike

[Charger1973]

You should make em and sell em'

[AKcharger]

How are you going to rotate the car and hold it in position to do the sides and bottom?

[Alain426]

i will drill some hole in the tubing, and put a pin (bolt) like a engine stand

its low budget, but it will work:)

thanks again for the comments

its not the most complete rotisserie, like ajustable height or rotate on bearing, but its cheap, low budget and easy and fast to do

[Silver R/T]

looks great, simple design also

[Alain426]

i finally got the ca ron the rotisserie, not an easy job, just me and my friend and my rotisserie in not adjustable

so here what its look like in my 85'' height garage  (i was afraid that the car was not able to turn in the garage, but all works properly im verry proud of what i did:)





im with the beer:)

[Charger-Bodie]

now get to work on that beast!!!!!!!!!!!

[mikepmcs]

That thing is awesome.  Good job fellas.

[rt green]

how easy was it to flip it over? how did you do it?

[Alain426]

my rotation point are aproximatly in the center, so me and my friend, (one each side) were able to rotate it without any trouble, very easy to do

[tan top]

nice fabrication  job  you have done there     awesome stuff

[XS29L9B2]

good work 

[Charger_Fan]

Very nice, congrats!!

[70 Charger RT]

simple yet effective.  I like!