News:

It appears that the upgrade forces a login and many, many of you have forgotten your passwords and didn't set up any reminders. Contact me directly through helpmelogin@dodgecharger.com and I'll help sort it out.

Main Menu

Park brake cable to actuator on a 68 - Bolt or pin to anchor?

Started by DanPratt, November 06, 2016, 02:06:36 PM

Previous topic - Next topic
Print
Go Down Pages1
User actions

DanPratt

November 06, 2016, 02:06:36 PM
Hi all,

Is it a bolt or a pin that fastens the park brake cable on a 68 Charger to the lever inside the cabin?  I can't find any pictures of that part of the assembly anywhere.  Looks kind of tight in there for a nut and bolt. Any help would be very much appreciated as I am putting together a car that I did not pull down.

Cheers,

Dan

cdr

#1
November 06, 2016, 02:45:31 PM
,
LINK TO MY STORY http://www.onallcylinders.com/2015/11/16/ride-shares-charlie-keel-battles-cancer-ms-to-build-brilliant-1968-dodge-charger/  
                                                                                           
68 Charger 512 cid,9.7to1,Hilborn EFI,Home ported 440 source heads,small hyd roller cam,COLD A/C ,,a518 trans,Dana 60 ,4.10 gear,10.93 et,4100lbs on street tires full exhaust daily driver
Charger55 by Charlie Keel, on Flickr

Lennard

#2
November 06, 2016, 03:23:26 PM
A pin and a sheet metal clamp "nut".

DanPratt

#3
November 06, 2016, 04:38:30 PM
Ah ha! A pin and pressed metal nut/clip thingy. I found a picture of one on ebay but the auction had expired. I'll keep looking but, thank you,  i at least know what I'm looking for now.  I could always make one using an e-clip too if I can't find one.

Thanks again!

Dan
Print
Go Up Pages1
User actions