News:

It appears that the upgrade forces a login and many, many of you have forgotten your passwords and didn't set up any reminders. Contact me directly through helpmelogin@dodgecharger.com and I'll help sort it out.

Main Menu

hemi cam install question

Started by werner, April 16, 2015, 10:32:27 AM

Previous topic - Next topic
Print
Go Down Pages1
User actions

werner

April 16, 2015, 10:32:27 AM
MP/ Ray Barton 528 Hemi.
Going to install new cam this summer. Assuming engine was built correctly and cam degreed, Balencer marking, pointer and cam and sprockets are marked correctly should I be worried about degreeing cam again if it is going to be installed straight up ?

If yes I guess i will have to make a tool for piston stop for degreeing cam and an air adapter to pressurize cylinder when I remove and install new valve springs.

Can anyone recommend a good valve spring compressor for doing them in car ?

Thanks Werner
1969 dodeg charger, 528 hemi ,Tko 5spd.
Print
Go Up Pages1
User actions