News:

It appears that the upgrade forces a login and many, many of you have forgotten your passwords and didn't set up any reminders. Contact me directly through helpmelogin@dodgecharger.com and I'll help sort it out.

Main Menu

measurement for window clip holes??

Started by green69rt, August 22, 2013, 11:26:46 AM

Previous topic - Next topic
Print
Go Down Pages1
User actions

green69rt

August 22, 2013, 11:26:46 AM
I replaced the upper cowl on my 69 charger and didn't think much about it till I started dry fitting my window in and realized that the new cowl from AMD did not have the holes for the window trim clip screws.  So now I need to drill them.   Can anyone give me a measurement of where they go.   I'll use that as a starting point and dry fit everything to get the exact spots.   Pics show what I'm taking about.

cdr

#1
August 22, 2013, 12:38:25 PM
see you about 2:00
LINK TO MY STORY http://www.onallcylinders.com/2015/11/16/ride-shares-charlie-keel-battles-cancer-ms-to-build-brilliant-1968-dodge-charger/  
                                                                                           
68 Charger 512 cid,9.7to1,Hilborn EFI,Home ported 440 source heads,small hyd roller cam,COLD A/C ,,a518 trans,Dana 60 ,4.10 gear,10.93 et,4100lbs on street tires full exhaust daily driver
Charger55 by Charlie Keel, on Flickr

green69rt

#2
August 22, 2013, 03:22:12 PM
Charlie, thanks again for the help.   I rushed home because of our talk about the quarter panel eyebrows.   Kind of in a panic, because I could see delaying the paint.  Lucky me, everything was really close, maybe 1/16" off but a big relief.  That's worth putting out on a thread.
Print
Go Up Pages1
User actions