help ---panel gaps 68 charger

[cdr]

i need some help PLEASE!  need some good up close pics of, prefer right side, cowl to fender & door,,door to rocker & door to quarter .

thanx charlie

[tan top]

there is a good thread i wrote on here somewhere , but cant seem to find it ,
fit your doors adjust gap between back or door & quarter
the  front top of door should be level with the top of cowl or near as damn it ,
fit hood , the rear of the hood gap to cowl , dictates the fender to cowl gap , (((( but don't make too small , other wise the door will hit the fender when opening ,,)))   should be one consistant gap or as near as possible ,  rear top of fender & front top of door should be level with top of cowl , adjust door in or out at the top to make the gap the same as the top of fender to cowl & rear hood to cowl ,  
   dont tighten anything fully until your happy with every thing ,  

[cdr]

i have been lookin ! thanx tan top, installing new quarter & need to get door correct before i do any welding on permanently