Vacuum feeding

[Belgium R/T -68]

Is it OK to attach the main vacuumhose for the headlight doors on the brakebooster or does it have to come straight from the intake manifold
or carburator?

Per

[mikepmcs]

it should be attached to the back of the intake manifold.

http://www.dodgecharger.com/forum/index.php/topic,10158.0.html

[Belgium R/T -68]

it should be attached to the back of the intake manifold.

http://www.dodgecharger.com/forum/index.php/topic,10158.0.html

Thanks Would it have any negative impact if I attached it to the multiple nipple on the brakebooster other then stocklook?

Per

[Belgium R/T -68]

Would I get less vacuum for either the brakes or the headlight doors?

Per

[Nacho-RT74]

the brake booster check valve niple is for the cruise control vacuum. Uses also a diff size hose. I would directly to the smaller tee at manifold source

[Belgium R/T -68]

Problem is I only have a single port on the manifold but could go straight from carburator.

Per

[Just 6T9 CHGR]

You would be getting full manifold vacuum to & from the brake booster check valve since you have the dual port check valve.

You can run the headlight doors off there.....I wont tell

[Belgium R/T -68]

You would be getting full manifold vacuum to & from the brake booster check valve since you have the dual port check valve.

You can run the headlight doors off there.....I wont tell

Thanks friend That was the answer I wanted, I have a few other things that is not 100% factory so......

Per