Filler neck cut out

[jmdesigns]

Hey guys,

The trunk has been replaced and I don't know what the cut out looks like or the location. Anyone have any pictures? Shown is the grommet I have and the trunk floor.

Thanks!!!

[mopar_nut_440_6]

I just had to do the same cut out and had no reference but used my old gasket to see approximately where the mating surfaces were. The following link will show some pictures of the bottom of my pan. You will also need to cut holes for the vent tube and a hole for the fuel sender wire by the spare tire mount area. The hole for the vent tube off of your filler will dump into the area in the centre of the LH frame rail.

http://www.dodgecharger.com/forum/index.php/topic,54980.msg623184.html#msg623184

Here is a link for jack mounts if yours are not installed.

http://www.dodgecharger.com/forum/index.php/topic,32239.0.html

Trunk plug holes.

http://www.dodgecharger.com/forum/index.php/topic,2346.0.html

I hope this helps!