Engine Compartment Wiring Done

[v21hemicharger]

Well, I have finished the engine compartment wiring.  I went with Nacho and the parallel wires to the amp meter, put in relays for the headlights and fan up front in a neat little box.  I used braided nylon sleeves with heat shrink on ends and where more than one wire comes out, and used AN fittings with cord protectors for grommets.  I moved around some wires in the bulkhead and ran the linelock thru there and will use the horn button to activate it.  I put in a switch to go from horn to linelock.

[v21hemicharger]

I installed the dash temporarily to find where the mech gauges will come out and took a look at where the X pype will go.  Will have to make a trans crossmember because of the gearvendor OD

[Charger74]

Very nice job.  Very clean looking.  Keep it up.

[Back N Black]

Very nice! What exhaust you have on there?

[Ghoste]

That is a slick looking underfloor pic.

[v21hemicharger]

That is Pypes stainless x pipe from summit.  Only about $180.

[Just 6T9 CHGR]

Very trick wiring set up there