Console assembly problems

[gasoline_24]

I was putting the PG Classic top plates and console lid on my Year One reproduction console, and I am having problems getting the lid to adjust.  There is not enough spacing between the shifter plate and the rear top piece which causes the lid to rub.  I cannot see any adjustment in the front or rear pieces to allow for more adjustment.  I know the lid adjusts, but this does not fix the problem.  I am wondering if either the reproduction console or the reproduction top plates are not exact and therefore there are some fitment issues.  Any help would be greatly appreciated.

[BROCK]

Without a stock part from which to measure the other parts from:  there is no way to match it to
stock.  Unless it has to absolutely be a perfect interpretation of the original product......

Just find the easiest places to shave material for a proper fit.

[The70RT]

Two different companys 

[gasoline_24]

Got it figured out.  I had the clip that mounts on the bottom of the shifter section mounted upside down.  I als thought the back section was tight, but the threads needed to be chased to allow tightening the rear section down all the way.  It still could use a little adjustment, but it is pretty good right now.  I guess you need to be smarter than the parts.  I didn't take any pics of this when disassembling like the rest of the car.   

[The70RT]

good deal

[Dodge Don]

Got it figured out.  I had the clip that mounts on the bottom of the shifter section mounted upside down.  I als thought the back section was tight, but the threads needed to be chased to allow tightening the rear section down all the way.  It still could use a little adjustment, but it is pretty good right now.  I guess you need to be smarter than the parts.  I didn't take any pics of this when disassembling like the rest of the car.   

That would do it.