Trunk fuel vent hole question...

[C500]

Hi guys,
I have a new AMD floor in. Have searched the forum, and cant find any measurements to drill the hole in the trunk floor for the '69 filler vent. Can anyone post up some measurements: hole diameter, measurement from edge of 'filler neck' hole and measurement from the small hole beside vent location.

[70 sublime]

I am just putting a new two piece AMD trunk floor in my 69 Charger

I took some pictures but hard to tell the numbers from the angle of photo
So with that said

I used the 4 small screw holes around the floor filler neck hole

Standing behind the car I put a straight edge on the two left hand side screw holes and measured over to the vent hole center I get 2 1/8 "

Next I put the straight edge on the back two screw holes I get 15/16 " to the center of vent hole which is also makes it closer to the back of the car

Hole appears to be 1 " even in diameter

Another way to look at it is the trunk pan has a rectangle raised section to accommodate the brace that goes across above the gas tank
The vent hole center is about even with the front edge of this rectangle and just to the left ( looking forward from the back of the car ) enough that it is on the flat section of the pan beside the raised rectangle

Clear as mud      

[C500]

I am just putting a new two piece AMD trunk floor in my 69 Charger

I took some pictures but hard to tell the numbers from the angle of photo
So with that said

I used the 4 small screw holes around the floor filler neck hole

Standing behind the car I put a straight edge on the two left hand side screw holes and measured over to the vent hole center I get 2 1/8 "

Next I put the straight edge on the back two screw holes I get 15/16 " to the center of vent hole which is also makes it closer to the back of the car

Hole appears to be 1 " even in diameter

Another way to look at it is the trunk pan has a rectangle raised section to accommodate the brace that goes across above the gas tank
The vent hole center is about even with the front edge of this rectangle and just to the left ( looking forward from the back of the car ) enough that it is on the flat section of the pan beside the raised rectangle

Clear as mud      

Not bad sublime