Trunk floor hole....

[1charger69]

Can someone tell me the diameter of the hole the gas tank sending unit wire goes through.....thx much!

[john108]

I have a 68 charger.
On the trunk floor, just to the left side of where the fill pipe goes through the floor, are two small holes next to each other.
One is 0.893
The other is 0.946

My car is not assembled so that is the best I can do.

[70 sublime]

I have a 68 charger.
On the trunk floor, just to the left side of where the fill pipe goes through the floor, are two small holes next to each other.
One is 0.893
The other is 0.946

My car is not assembled so that is the best I can do.

Those are not the holes for the gas gauge wire to go through
The wire hole is in the center of the floor just before the hump over the rear end
I can measure mine in the morning if no one else answers before then

[john108]

I found a single hole in the center of the floor just before the hump.
Mine isn't perfectly round because I coated that part of the floor with bedliner but:
It measures 0.687 to 0.723

[tan top]

Can someone tell me the diameter of the hole the gas tank sending unit wire goes through.....thx much!

    best measure the blue sender unit wire , grommet  you have ....   reason being , I found  ,  the new repop harness sender grommet was  smaller than the OEM one