flex plate bolts big block bolts

[sgt72charger]

flex plate bolts big block bolts

not 100% sure how this is supposed to be installed.
This is my first time ever touching a automatic transmission

my question is does any one know where i could source these bolts and how does it get installed it bolts to the fly wheel then just put the torque converter in the tranny and slap together ?

any help greatly appreciated

72 charger 440bb + 727 tci street fighter transmission

[John_Kunkel]

Mancini has the bolts:

http://chucker54.stores.yahoo.net/flexplatscre.html

Flexplate-to-crank bolts are always the same but the converter-to-flexplate bolts come in  different sizes. I always use red Loctite on these bolts. The flexplate bolt patterns aren't symmetric so it can only go on one way; it's wise to fit the flexplate to the converter and mark flexplate and converter to make it easier to align the bolt holes after installation.

It's important that the converter be installed in the trans so that there is at least 1/2" from the mating surface of the bellhousing to the converter drive lugs, otherwise pump damage will occur. IOW, once the trans/converter are installed on the engine you want a small gap between the drive lugs and the flexplate so the converter needs to be pulled forward against the flexplate before the bolts are installed.

[sgt72charger]

thank you

well i just ordered the hardware.

sounds a little confusing,  well I am also the sharpest tool in the shed

would you be able to break it down step by step? like what i should install first ?
is there a torque on these bolts ?

[ACUDANUT]

"sounds a little confusing,  well I am also the sharpest tool in the shed"

Why it is so hard then. 

[sgt72charger]

"sarcasm"

[ACUDANUT]

Roger that...Over