Does anyone know where to source this part?

[Mfr426]

Hey All, I am short (2) spacers for the rocker arms on my 69 Charger. These are the stock 3/16" spacers that sit in between the left and right rockers on the rocker shaft. I've attached a pic of a set of them.

There are (4) per rocker arm shaft. I can not seem to find these anywhere locally. I went to Ray Bartons and they had ones that are a tad wider than the stock ones but they appear to bind the rockers when I put them in. I DID find a set on ebay but I dont want to buy a full set since I only need two. I'll even be OK with used ones at this point since they dont appear to be a wear item.

If anyone has an extra or two and wants to sell them let me know and I'll PayPal you or send you a check. I thought finding these would have been easier. Any dealer p/n's would be helpful as I would be fine getting new at the dealer.

Thanks for any help.

Miike Roberts
aka
MFR426

[Blown70]

Hahah, I have a PILE of engine stuff from a 440.  I can look for you and you can have them if you want.......LMK.

[Mfr426]

THANK YOU for the offier! I'll take you up on that. Let me know what I owe and I'll send you my address.

Thanks!

Mike R

[firefighter3931]

Mike, i have some of those kicking around as well. If Tom can't find any i got ya covered. 


Ron

[Mfr426]

Thanks Ron (and Tom)!

[mopar0166]

If i may ask,  if you cant find "new" spacers and haev to use orignal ones, what is an acceptable wear or size difference from .200 ?  I may be over thinking this but i just wanted some confirmation

the ones i have vary from .197 to .201 , depending on how accurate my calipers are