Pic request of power window wiring from pillar to door

[Dino]

I'm not using the old rubber cones and I'm going to run power window wiring and some extra wiring from the kick panel through the A pillar to the doors.  I'd like to use the stock location and I'm guessing on the pillar side it's the dimple in the middle that needs to be drilled...but where on the door does the wiring enter exactly?

[69 OUR/TEA]

You want a picture of just the door or both , the A pillar as well ?

[Dino]

You want a picture of just the door or both , the A pillar as well ?

The door alone would be a great help.  I think the dimple on the A pillar is where the other hole goes but I won't object to a picture of it.   

I found a few pics on here of the floor boards but I don't have the hold down clamps on my car so I'll have to secure the wiring loom in some other way.  In the pics I can see roughly where the loom runs to all windows so once I know where they pass through the doors, I should be able go figure it out...probably.   

Thanks!

[69 OUR/TEA]

These are the exact hole locations and sizes , the driv door jamb is diff than the pass door jamb , but both doors are exactly the same .

[Dino]

Awesome!  Thank you very much for those pictures!  That takes care of that problem.   

I'm not reusing the big conical grommets and will be looking for a rubber door loom.  The only angle loom I can find is only 4" long though and I don't think that's enough to go from pillar to door.  They may also be too narrow as I need to run the power window wiring + speaker wires + power door lock wires. 

http://www.autotoys.com/x/product.php?productid=14643

The holes seem further apart than 4" as well but now I can measure it up exactly.

Thanks again!

[Dino]

Alright, for those wanting to know, the distance between the center of the holes, pillar to door, is roughly 7.5" on the driver side and 6.5" on the passenger side.  Now all I have to do is find the looms and I'm good to go!

I did see that the holes in the a pillar are so high that it looks like the wire will be passing right behind the side a/c vent hose.  I'll take that apart tomorrow and see what I can see.