Interior trim for rear glass

[journeycharger69]

Does anyone know how to install the interior trim that goes around the rear glass?  I purchased a 5 piece set and there is no way to make it fit that I can see.
Thanks

[twodko]

John, there should be exposed metal edges all around the rear glass outboard of the serrated edges the headliner attaches to. The trim has a slit along the back side that slips over these edges. Start at the top and work you way down. Hope this helps.

[tan top]

John, there should be exposed metal edges all around the rear glass outboard of the serrated edges the headliner attaches to. The trim has a slit along the back side that slips over these edges. Start at the top and work you way down. Hope this helps.

[journeycharger69]

Thanks!

[journeycharger69]

 I just looked and I do not have the serrated edges.  How do I find some?

[doctor4766]

I just looked and I do not have the serrated edges.  How do I find some?

Maybe it was a serated edge delete car???


Is your back window out?
Hoodlining still in?

[journeycharger69]

The rear glass and headliner has been installed and we were trying to install the interior trim.

[doctor4766]

Could be wrong here but I think it's easier to fit those trims before the glass goes in, and the serated edge is now covered by the hoodlining.

[twodko]

John, is there a lot of excess headliner material  cut too long after the serrated edges? I ask this because perhaps this excess is might be obscuring the trim mounting edges. I'll be curious as to the outcome here because there has to be this edge otherwise the factory wouldn't have been able to mount the trim at the factory.

[journeycharger69]

There is no excess headliner, I ran my fingers on the inside on the headliner and feel no serrated edges. 

[tan top]

   thats odd  !! how is the head liner attached then  to keep it tight  ??   
  have you got a picture ??