Trans Line Route

[69fourspd]

I have some repro lines from Fine Lines going into my 69 440/727.  This is a complete resto so I do not recall where the lines run.  Looks like they will need to go between the motor and PS gear above the K-member.  I have the radiator in already, but from the looks of it I think I need to remove this to get the lines in.  Can anyone give any tips or pics? I have searched and searched and cannot find anything.  Always appreciated.

[gtx6970]

exists the trans , runs along the engine oil pan, above the steering linkage ,  between the pan and engine mount, above the K-menber and connects to  the radiator

piece of cake to install even if the radiator is in the car

I put the car up on a lift ( jack stands will work as well) and snake them in from the back side

[John_Kunkel]

Don't forget the standoff bracket that mounts to the bottom starter bolt...without it the lines can rub the bellhousing and eventually wear a hole in the line.

[Just 6T9 CHGR]

Don't forget the standoff bracket that mounts to the bottom starter bolt...without it the lines can rub the bellhousing and eventually wear a hole in the line.

[69fourspd]

Thanks guys! The description and pics helped alot.  I got the lines in without too much trouble.  Looks worse than it is...

For anyone else, I used the Fine Lines Stainless set and they fit pretty good.   The drivers side line was a little off, but a little elbow grease made it fit just fine. 

Thanks again!