How do I adjust/tighten side glass on 69?

[General Ryan]

My door glass and vent window assembly has about  a 1/4-1/2 in of play in it.
I want to tighten/remove the play but don't know how.
I've had the upper and lower door panels off and don't see where I would adjust it.

My side glass does not seal at the top with the rear 1/4 window. The gap gets bigger as you look up the window with about a 1/4 inch gap between the two windows at the top.
Do I need to adjust the angle of the door window or what??
The pass. door does the same thing but not as bad as the dr. side.

Thanks,
Ryan

[Animal]

The door glass is a pain to adjust @the best of times,even when you have all new seals.Anyhow,the front stainless frame has two fixings in the front,(remove rubber plugs,in front of door cards)to where you can get up & down movement.The rear 1/4 glass can be adjusted in & out,by the adjustment bolts behind the rear upper door pads.Good luck.You may be doing this for a while.
Adam.

[Animal]

Nearly forgot,there is an allen bolt that also holds the frame in.Loosen this & you can move the frame up & down.
Adam.

[tan top]

  there is a adjusting bolt for the vent window frame on the bottom of the door under a black plastic plug. there is also adjustment  on the glass run channels , glass lowering  stop & rear winder . to get it 100% dialed in takes some time .especially if you have removed every part for a  resto

[Rolling_Thunder]

doing this just flat out sucks...    ask me how i know