correct fasteners for trim

[poppa]

I apparently used really cheap baggies to store my fasteners/hardware and most have ripped leaving me with lots of screws/bolts/nuts at the bottom of my box. Does anyone have a pic of the right screws to attach the roof rail trim/weatherstrip ? I will probably need more help identifying others. Does this happen to alot of others? Maybe a sticky on the subject??

Merry Christmas to all.

[tan top]

cant remember   for sure but they are phillips pan head !!  take a picture of all screws , & well prolly beable to tell you where they go !! , 

[twodko]

I'm not clear on what you're asking. Based on your profile I believe you have a 69 like me. If you mean the SS trim that goes over the drip rail itself, there are no fasteners, it sorta rolls/snaps into place. If the weather strip you're talking about is the long rubber gasket that the windows roll up into, you just push it or pinch it into place. 

Happy Holidays!

[tan top]

  think its the upper  roofrail weather strip channel 

see green arrows

[poppa]

Yes,Tantop is correct.I pulled some out and seperated them,this should keep me going for a bit. Also found some mystery clips,these are the screws....

[poppa]

And these are the clips...Thanks for the help guys. Merry Christmas !

[tan top]

screws marked A  are for the roof rail weather strip channel
screws marked B  are for the  inner stainless trim or the door & rear quarter &  rear quarter  shaped frame , thingy  never sure what this thing is called 
see pictures

[tan top]

 clip marked    1  are the factory  headliner side roof flange attaching clips , the new MP ones are a 1/4 inch taller

see picture  below

clips marked 2 are the inner roof side trim !! see picture two

clip three  , not sure , did not have that on mine !!  have you power windows
also screws C are they small than  screws B ??

[poppa]

Thanks Tantop. Do you know off hand ,how many of each clip I would need? Screws are easy to figure out. Thanks again,and Merry Christmas....

[tan top]

Thanks Tantop. Do you know off hand ,how many of each clip I would need? Screws are easy to figure out. Thanks again,and Merry Christmas....

well mine had never previously been appart ,  & had 6 on one side  & 3 on other    i would not order any of the new MP ones as they are too long & show above the  inner roof rail trim , !!  try to get hold of as many original ones as you can !!  or make  some !!  i used  about 20 aside  doing my  headliner !!  & always use lots when doing this type
but every one has their own way !! & prolly use less ,  but not got any wrinkles & is drum tight !!  

iron headliner from the back a few times  to get the sat in box  creases out  dont  iron to slow ! ,  then let it sit in sun for a while before fitting , then use hair dryer for heat as you go !  

[MRCHARGER]

Clip 3 looks kinda like a vent cable end attaching clip found on the heater box. But they have a hole for a philips screw in some applications so I don't know for sure. Could be a windshield moulding clip with the center section broke out.

[poppa]

Mr Charger , Tantop , Thank you. You have been most helpful.

[gtx6970]

clip #3 looks like it's for the left remote mirror adjuster bezel to door panel

[poppa]

gtx6970,Thank you for your help.