YearOne windshield gaskets

[Charger4404spd]

I replaced the OEM gasket with one from YearOne. I didnt notice until after it was in, but it is thicker than the original and I am unable to use the wipers due to interference with the thicker gasket.

Anyone else ran into this? Did YearOne have some that were not correct?

Part #WCRD715 for 68-70 b-body.

[tan top]

fitted mine , it was from yearone , for get name of the manufacturer , but the sealed bag it came had dark green print on it from memory ,  & was a exact duplicate of the original , all be it soft  rubber !! , fitted ok , no problems
but got this about 9 years back 
part number rings a bell also , will have to check 

[doctor4766]

fitted mine , it was from yearone , for get name of the manufacturer , but the sealed bag it came had dark green print on it from memory ,  & was a exact duplicate of the original , all be it soft  rubber !! , fitted ok , no problems
but got this about 9 years back 
part number rings a bell also , will have to check 

Yep, should be correct as W715 is the NAGS part number for the glass.

Charger4404spd can you elaborate more or show a pic of the rubber installed?
You haven't forgotten to lock it up have you?

[charger Downunder]

It would have to be way too big to hit the wipers. Is it hitting the wiper arm or blades.

[Charger4404spd]

It is hitting the rubber blade, about 1/4". This YearOne gasket comes down the window more than the original.

[Charger4404spd]

[tan top]

are they the original length wiper blades ,  
heres a picture i have saved of mine dont show much ,  i'll go and measure the wiper blades later on mine

  EDIT ****ok been to measure mine ****

wiper blade 14 3/4 ''( original , but replace just the rubber )   ,   windshield rubber top to bottom middle  20 3/4'' give or take a couple of thousants

yeah i know the blades are sitting low !! long story , but park in correct position now  

[doctor4766]

It is hitting the rubber blade, about 1/4". This YearOne gasket comes down the window more than the original.

Ok that's a bit clearer now.
Looks like you need to push that rubber further under the crome with your thumb.
I had the same issue with mine and it didn't come from Y1.
See how there's a small gap between the rubber lip and the molding?
I'll bet you can press that in a bit further like I did so it's more flush.
Not sure on these if the wipers are left and right either (I'll check today) unless someone else already knows.
A lot of vehicles' wipers are side specific and it may only be a couple of extra mm difference.

[Charger4404spd]

I see what you mean Doc.... it does look like it needs to tuck in under the trim some more. TanTop, I just measured mine and it is 20 3/8", so it does appear that I need to get that rubber pushed on up under the trim some more. I just tried pushing a section of it up in under the trim, but it doesnt seem to want to go. I will try again this week when I get time. If it will go on up under the trim though, I think that will solve the problem. Thanks guys!