Hats off display for the 6 pack

[b5blue]

'70 GTX that was at the Triple X show in '08 up there with a similar set up.

Yep I think that was the one. I really like the way he did his with the real thick Plexiglas. Must have been a real pain to cut that though.

Why is it that every pic like that I see of the six packs never get me a real nice angle of where the kick down rod is suppose to connect to. Grrrr. I really need to see what that looks like close up

As soon as my camera battery charges up I'll post a photo of mine for you Kelly. 

[70charginglizard]

Thanks Neil 

[OneofNoneRT]

MAN!  Dont forget to remove it (Plexiglass cover) when you start up! Could be very interesting if fuel vapors come back up when it stalls out.. Or am I just being Paranoid? 

[Neal_J]

Why does the center carb have a top "tier"?

Wouldn't a flat piece of plex sit across the top of all three carbs?


Not-Six-Pac-Familiar,

Neal

[70charginglizard]

Why does the center carb have a top "tier"?

Wouldn't a flat piece of plex sit across the top of all three carbs?


Not-Six-Pac-Familiar,

Neal

Center carbs got the butterfly valve which make it sit up higher by about 1/2 inch.

You have to cut a hole in center for this to go thru so you can use the stud mounting locations of the fwd and aft carb and then use a seperate cover for the center one. Otherwise your just covering the outbd carbs only. I want all three covered up for protection during display

[FlatbackFanatic]

Very cool looking..

[b5blue]

Kick Down Linkage.

[70charginglizard]

Kick Down Linkage.

Thanks bud.

Could for the life of me remember the correct connection points for the rear spring. Now I know.