Where to get the correct retainers to hold the vaccum lines to the inner fender?

[Corellian Corvette]

I'm doing some engine compartment research and it looks like the vacuum lines for the headlights are retained using some clips on the inner fender.

Anyone have a pic of what these clips look like, and a source to get them?

Thanks!!

[Rolling_Thunder]

mine were ran along the inner fender along with the stock underhood wiring strap kit   

[Corellian Corvette]

I'm fairly certain the vacuum hoses have a clip they are taped to, and mount up on the inner fender. I was wrestling with getting all the hoses, battery cable, wiring, etc. under those clips and I figure out why. Found this picture in this link http://www.dodgecharger.com/forum/index.php/topic,22311.0.html



Also the assembly manual shows it having a clip as well (at the top "view in circle w")



Whatever clip that is, looks like I need 2 or 3 of them

[maxwellwedge]

It is the same clip that E-Bodies use to clip the headlight harness onto the inner fender by the battery. They were usually taped on each side of center. I will try and find a pic.

[Just 6T9 CHGR]

It is the same clip that E-Bodies use to clip the headlight harness onto the inner fender by the battery. They were usually taped on each side of center. I will try and find a pic.

There are (2) "T" shaped push in clips that hold the vac hoses to the top of the inner fender.....the hoses rest in the middle of the clips & the electrical tape secures the hoses to the clip.
I got my set used from a friend....I heard that Ford uses them as well....

[Corellian Corvette]

So I take it not reproduced then? Gah! That's going to be hard to find...

[Just 6T9 CHGR]

So I take it not reproduced then? Gah! That's going to be hard to find...

They might be by now....maybe drop Bill Allphin a note?

http://amhightechauto.com/

[maxwellwedge]

I have also seen a similar clip on 70-71 440-6's. It was one style that was used to hold the idle solenoid wire...We call it the "T" clip" style. I know who has those - I will ask him if it is similar.

[CornDogsCharger]

It should be pretty easy to find.  Many modern cars to this day still still use the same clip.

Justin
"CornDog"

[FJ5WING]

It should be pretty easy to find. 

Justin
"CornDog"

thats what everyone says about the hood pop up spring retainers.

[maxwellwedge]

Here is one style of the solenoid clip I mentioned earlier. I believe it is the same or darn close to the harness clips. Sorry - crappy pics.

[FJ5WING]

I also found one along the rear main electrical harness holding the harness to the trunk floor near the left wing support. 

[Corellian Corvette]

My 73 vette uses the exact same clip to hold the idle solenoid wire. I checked the vette parts vendors and can't find it.

C'mon! Anyone?!

[gtx6970]

These ?

Not avail in white at this time though

[Corellian Corvette]

FOUND!!!

Correct - not in white, but RT Specialties has them called a "Wire Strap". $3 each! Just ordered!

[maxwellwedge]

Frank Badalson has them in white - sorry - I was late!