Trim/clips to run wires underneath

[Nacho-RT74]

How tranny harness and speedo wire run underneath the floorboard ? and on frame rail ? what clips are used ?

is for 3rd gen ( 74 ) but I don't thing earliers are too much different

[Charger74SE]

How tranny harness and speedo wire run underneath the floorboard ? and on frame rail ? what clips are used ?

is for 3rd gen ( 74 ) but I don't thing earliers are too much different

The trans harness comes down the passenger side of the case then crosses over the top to the safety switch. The Speedometer cable comes down from the firewall and attaches to the frame clip then to a clip thats welded to the bottom of the floor pan then it connect to the trans.
There are 3 clips for the transmission harness and 1 clip for the speedometer cable that attaches to the side of the frame. See pics.

[Nacho-RT74]

The trans harness comes down the passenger side of the case then crosses over the top to the safety switch.

REALLY ?

The Speedometer cable comes down from the firewall and attaches to the frame clip then to a clip thats welded to the bottom of the floor pan then it connect to the trans.
There are 3 clips for the transmission harness and 1 clip for the speedometer cable that attaches to the side of the frame. See pics.

I got an used tranny harness with the clips on top ( just the two ones ) and I was searching where should it be attached


and I'm running both together using couple of clips attached to body, so I didn't find where to attach those clips


I need to know where it should be attached the clips and where should be running both stuff