B-Body Instrument Circuit Board Pin-Repair

[GeneralLeeTESH]

Take a good mild copper-etching cleaner and then using Rosin core solder, re-solder broken pin/pins with copper stranded wire within the pin to the board. Dothis for each pin. Then do a continuity check ! Now-stabilize the pins with a pre-drilled (use 1/8" bit) popsicle stick-cut to fit, split down the middle in a 45 degree downwards bend. FILL the popsicle stick within the area with 5 minute epoxy-IT works great-and your wire bundle can literally hang off the back. This set up is a GREAT Strain Relief for the pins !

[Just 6T9 CHGR]

Nice write up!  That will never break again I'm sure.