Neutral Switch harnes

[q8charger]

Hello,

Any one know where the harnes 727 chrysler Neutral Switch 3 long  pins place? .  For 1969 charger

[Gold Rush]

We can't tell from your question what you are looking for.  Do you need a source for a new harness or are you looking for how the harness is routed?  Or, maybe some other question....    

[Bronzedodge]

English not a first language.     Welcome.  The plug goes into the neutral safety switch on the transmission.

[birdsandbees]

Blue arrow!

[MoparRocks]

Since we are on the topic and being informative about them. Anyone got a pinout for the plug on it as far as which pin goes to what? Doing a complete rewire on my Charger at the moment.

[Nacho-RT74]

Since we are on the topic and being informative about them. Anyone got a pinout for the plug on it as far as which pin goes to what? Doing a complete rewire on my Charger at the moment.

outer pins are black solid and black traced white wires ( no matter which one ) and gets the reverse lamps signal ( in and out ). One is hot from acc source, the other gets hot when reverse is geared. ( can't recall if the hot should be the traced or the solid wire, although just for correctness )

the center one is the ground signal on brown traced yellow yellow to the G terminal at Starter relay

[q8charger]

Sorry for the delay and confusion . What i  meaning  Where is the places of the 3 wires  should be ?

[MoparRocks]

Check Nachos reply above. That's what I was asking as well. Think I have it figured out now thanks to Nacho.

[Mopar Nut]

Top wire with plug goes to the starter relay, other two plug into the bulkhead plug.

[Nacho-RT74]

ok as mentioned... the two loosen male terminals runs to wiper motor bulkhead plug... SOME CARS ( can't recall if 2nd gens B bodies but A bodies did ) got an intermediate 2 ways plug before reach the wiper motor plug, but if didn't simply runs straight to the wiper motor plug at firewall. Need to find which cavities. If you don't have the diagram ( easy to find around ), simply check on back of firewall which cavities are. Usually the cab side wires are white and white traced wires, not anymore blacl, but can't recall on 2nd gens.

brown traced wire runs as mentioned to the G terminal of starter relay

[birdsandbees]

Upper two sockets spots on passenger side of the bulkhead connector / wiper motor plug. Solid black to the passenger side and stripped wire beside it.

This picture is for a 4 speed, your extra wire goes to the G terminal (bottom drivers side) on the starter relay.

[Nacho-RT74]

Ok so is a fact 2nd gens B bodies got also an intermediate two ways plug, like A bodies, angled plug

[birdsandbees]

On the 4 speed anyhow, don't believe their is one on my automatic Superbird... will have to look next trip the hangar.