Front and rear window trim clip questions, 70 Charger

[jlatessa]

Can someone help  me on location measurements for the top of the rear window,
I haven't enough holes showing after the bodywork to figure out the rest?

Also on the sides of the front window I have two upper holes showing,
but it looks as if there should be a lower one on each side for symmetry.

I was supplied 10 of the large clips for the front bottom, but only can see 8 recesses,
just extras??

Thanks everyone, Joe

[green69rt]

Here's a must read for the front window.  I'll see if I can find something for the rear.

http://www.dodgecharger.com/forum/index.php/topic,55510.msg617204.html#msg617204

[green69rt]

Here's a thread on the rear window although it doesn't say what the clip spacing is.  I couldn't find anything though I remember seeing it somewhere.

http://www.dodgecharger.com/forum/index.php/topic,89520.0/topicseen.html

[jlatessa]

Well I got the back window squared away with member's referencing some threads, Thanks

Also, when the bodywork was done the two endmost recesses on the windshield's bottom were mudded over.
I was able to grind out the filler and re-drill the holes, all is well there now.

Only question left; do the front pillars get two or three clips each?
I can see what looks to be the remnants of two Phillips headed screws near the bottom of the A pillar,
is that where the third clip goes or is that that where the little L shaped retainer at the corner gets fastened??

Thanks guys, Joe