440 spark plug wiring layout

[RECHRGD]

I'm getting a Firecore RTR distributor and plug wires from Ron.  I'f never been real happy with any of my plug wiring layout choices in the past and would like this installation to look clean and tidy.  I would love to see some pictures of how you guys have run them and kept the engine bay sanitary.  Thanks in advance, Bob.......

[RECHRGD]

I should add that I'm running 1 7/8" hooker comps.......

[moparnation74]

I had no problems with the fitment of my firecore wires.  They actually were a tad bit longer than the factory repro set I had.  Which made the fitment and look better.  My only difference is I have factory manifolds.

[Dino]

I'll see if I can dig up some pictures.  I bought plastic clamps from Summit that Ron recommended and used those to run my wires.  I also used the stock wire tree that's on the front rail of the intake manifold to secure one of the wire retainers to, but I turned the tree 90 degrees so the wires would not hit anything hot.  It could not fit any better this way.  The wires run behind the a/c compressor without touching it.

[firefighter3931]

Bob,

Order 2 sets of these wire seperators and you'll be good to go 

http://www.summitracing.com/int/parts/aaf-all81345/overview/


Ron

[RECHRGD]

Thanks Ron and Dino.....

[Dino]

That's the ones!   

Haven't found a decent picture of it so I'l swing by the storage unit and get some.

[1974dodgecharger]

or just use zip ties....

[RECHRGD]

That's the ones!  

Haven't found a decent picture of it so I'l swing by the storage unit and get some.

Thanks!  You don't have to, but still would be cool to see a visual.......

[WHITE AND RED 69]

I have a set of RM specialties separators on my 440. Keeps them all in place and works great. They include spacers to help clear the header tubes if needed. And they are made for mopars so they fit perfectly against the valve covers.