1968 Charger Floor Pan Help !

[Mopar Crazy]

I had new front floor pan installed a while ago. I'm missing the (4) bucket seat track inner support plates.
Called AMD and they don't sell them. Any ideas where I might get them ?

Thanks MC 

[tan top]

if these are the parts that i'm thinking of your missing ?  AMD list them



https://www.autometaldirect.com/main-floor-pan-support-set-4pcs-66-70-dodge-plymouth-b-body

if its not these ?  the flat reinforcement plates  either side of the trans tunnel  , thought sure they were already spot welded to the new floor,  not sure if ive seen them on their own for sale , if there is no chance finding used , could make up a set pretty easy from flat sheet sutable thickness 

[tan top]

****** UPDATE *******    found the inside reinforcecment plates  yearone sell them

https://www.yearone.com/Product/chrysler-b-body/cr214a#prettyPhoto

[Mopar Crazy]

Thank you for the reply Tan Top...

I have the 4 L Brackets, they are for the outer 2 seat track bolts.  the 2 inner track bolts had 4 4x4

metal plates in the photo. I couldn't find anyone who sold these, so I have a fabricator making the

support plates. 

Thanks again MC 

[Wingnut426]

PM SENT.

[70 sublime]

I have never seen the extra plates on the inner bolts on the bottom before
They have always been on top of the floor inside the car

[tan top]

Thank you for the reply Tan Top...

I have the 4 L Brackets, they are for the outer 2 seat track bolts.  the 2 inner track bolts had 4 4x4

metal plates in the photo. I couldn't find anyone who sold these, so I have a fabricator making the

support plates. 

Thanks again MC 

oh right those plate thingys  i was thinking actual reinforcement plates factory spot welded to the floor not what i was thinking 
thats good your getting it sorted 

I have never seen the extra plates on the inner bolts on the bottom before
They have always been on top of the floor inside the car

you dont see very many cars with them & ive seen an unrestored well it looks un messed with, 69 charger with those plates just for the driver side outer seat mounting studs ( front & rear closest to the rocker) could of been all 4   that car had a factory 6 way seat option. so assumed for six way seat ( never assume ) seen on a few 70 b-bodies just on the out side driver seat studs cant remember if they were 6 way seats sure ive seen one or two with all four on the drivers seat studs cant be 100% sure but have seen them or something like them , maybe on a E-body also  unless i'm getting confused with something else , quite possible         
I await to be corrected on anything     

[tan top]

been searching for any B -Bodys with 6 way seats  would  like to back up what i mentioned above , cant find any so far may be i did dream it up  
  thought sure though   anyways heres those plates spot welded to E -Body barracuda & challenger floor