Bumper plate and screw 3rd generation seat

[billrabe]

I am working on reupholstering seats for a 1973 Charger and I am not sure what the bumper plate and screw look like. I believe it should be a washer about an inch and a half in diameter but the hole in the seat bottom is small, more like a screw size. I found a washer with the seat parts but no screw that would work. The hole in the washer I have is over 1/2 inch in diameter. The seat was disassembled by my son and no picture was taken of this item. If someone could please post a photo and/or tell me what screw size is needed I would be very appreciative.

[billrabe]

Would these bumper stops from 1971-72 Chargers work on a 73 seat frame? My seat had a plain washer screwed into the seat bottom, I think this might be the correct item. Can anyone with a 73 or 74 charger seat verify if this is the correct part?

[Nacho-RT74]

it should... seat bottoms are the same between all 3rd gen. My car got springs and retainers though

[billrabe]

Thanks! I ordered a set and will try them and post my findings.