Superbird Nose Seal Placement

[Aero426]

I am trying to help a club member place the new nose seals on his car that is in the restoration shop.   Does anyone have photos of the respective seals and where they go?   I know there have been various photos posted here in the past.   Just do not have time to search and am asking for help.   He says he has eight seals.   He understands the large ones on the fender and the small square one with the slotted hole for the rad support area.   It is the rest he is stumped on. 

[nascarxx29]

Dave at PCG might have a diagram.His ad mentions installation placement photos/instructions

http://www.performancecargraphics.com/Winged_Car_Stuff/Air_Block-Off_Seals.htm

[moparstuart]

 

[nascarxx29]

http://www.dodgecharger.com/forum/index.php/topic,68871.msg776586/topicseen.html#msg776586

[Aero426]

Dave at PCG might have a diagram.His ad mentions installation placement photos/instructions

http://www.performancecargraphics.com/Winged_Car_Stuff/Air_Block-Off_Seals.htm

He called PCG.  He says they were not keen on assisting him because he did not buy them there.     Vendor he purchased from apparently did not know either.

[Arnie Cunningham]

Testing to see if my photos are small enough to load.

(2) 3571 172
(2) 3571 163

[Arnie Cunningham]

(1) 3412 692 Battery Cooling Hole Seal

This is a hard one to photograph on an assembled car.  The seal is in the background.  You can see the edge of it and the "cut out".  I have never gotten a decent shot of how the hardware holds this one in.  If anyone has shots of the hardware please let me know.

[Arnie Cunningham]

(2) 3571 164 Inner Fenderwell Splash Shield

The fit on these kind of explains itself.  The threaded holes are circled in red and one is out of the photo (I think).

[Arnie Cunningham]

(1) 3412 691 Bottom Center Valance Panel Seal

This one is held in with two nuts like the ones on the throttle linkage and two plastic push pins like those found on any C body seals.  The nuts screw onto some overly long versions of bolts that come up from below.  If you are careful you can get the plastic push pins off an old car without breaking them.  They are installed from the inside with the pin leading to the outside of the nose.

[Arnie Cunningham]

(2) 3571 162 Nose Cone to Fender Seals.  Hemi Tyme has the best description for how to make these fit.  Maybe Ken will see this and chime in.  They look weird when installed wrong.

[moparstuart]

Dave at PCG might have a diagram.His ad mentions installation placement photos/instructions

http://www.performancecargraphics.com/Winged_Car_Stuff/Air_Block-Off_Seals.htm

He called PCG.  He says they were not keen on assisting him because he did not buy them there.     Vendor he purchased from apparently did not know either.

wow that shocks me Dave usually send me templates and stencils for free as long as i pay shipping 

[DAY CLONA]

This is a hard one to photograph on an assembled car.  The seal is in the background.  You can see the edge of it and the "cut out".  I have never gotten a decent shot of how the hardware holds this one in.  If anyone has shots of the hardware please let me know.




....

[Arnie Cunningham]

Ah excellent shot of the battery cooling hole seal.  Were both the Daytona and Superbird seals riveted on or did some use bolts with a captive washer.  Also what is the dot in the upper left corner of the seal?
Thanks