NEED MEASUREMENTS PLEASE superbird fender scoops studs

[Aero426]

I have to dig out the scoop and I can do it.   I have it at home.

[DonC1]

 

[Aero426]

This is a LH scoop.

All measurements on the middle and rear studs are from center of stud to center of stud. 

Forward stud is from the edge of the scoop to the center of stud.

[Aero426]

Distance between the two pairs of studs is center to center.

Center stud is measured from edge of scoop on each side.  

An "X" measurement on the four studs is 8 15/16".

What else do you want to know?

[Alaskan_TA]

Dimensions of the holes on the fender? 

[moparstuart]

Distance between the two pairs of studs is center to center.

Center stud is measured from edge of scoop on each side.  

An "X" measurement on the four studs is 8 15/16".

What else do you want to know?

thank you so much doug for taking the time to do this

[DonC1]

One last question would be the shoulder height of each stud shoulder/casing....Thank you Sir!

[Aero426]

Don, I will get that for you tonight when I get home. 

[WINGIN IT]

Doug, you da man.

I would have just punched the studs with a sheet of paper , wrapped it around the edges to get the form and sent it to him 

[moparstuart]

Doug, you da man.

I would have just punched the studs with a sheet of paper , wrapped it around the edges to get the form and sent it to him 

or punch the stud and trace the outer edge and then write the measurements on the paper and scan it or take a picture of it 

[WINGIN IT]

Ooooo, scan it, very techy Stu. Wouldn't have figured, 

Doug did it correctly though.
Whodda thought the studs weren't perfectly square to each other, IIWII I guess.

[Aero426]

Doug, you da man.

I would have just punched the studs with a sheet of paper , wrapped it around the edges to get the form and sent it to him  

U R way mor smarter than I is.      

[Aero426]

Height of plastic pedestals - measured from the edge abutting the blue tape:   ("Outside" means as mounted on the car, farthest from centerline.)

Forward Center Stud: 1 1/8"

Middle Outside Stud: 1 3/8"

Middle Inner Stud:  1"

Rear Outside Stud: 1 11/16"

Rear Inside Stud:  1 11/16"

[WINGIN IT]

Is there a place on the site to archive stuff like this?
( so Doug doesn't have to do this again  )

[moparstuart]

This is a LH scoop.

All measurements on the middle and rear studs are from center of stud to center of stud. 

Forward stud is from the edge of the scoop to the center of stud.

don need one more measurement if possible please   , thanks guys 


     front of scoop edge into the 1 st two bolt edges...left and right....make sense?...ie how far back are the 1st two threaded rods from the front of scoop?

[Aero426]

I'll measure it later tonight.

[odcics2]

Keep in mind that they could have had more than one mold making each scoop....  So they may all not be the same.