Anyone use a goodmark rear valence for 69 charger?

[Ryan]

Has anyone used one? I'm not very happy with my AMD one and would like to try somthing else as its going to be 6 months before AMD has it fixed.

[Charger-Bodie]

The goodmark one ait bad ,but I think its missing the two ears that weld to the rear crossmember, between the rear bumperettes.

[spoolinhard]

If you are unhappy with the contour where it meets the top of the valance corners, I would pull the valance back off and bang on it with a hammer and dolly until the contour is correct. If it can't be beaten into submission then I would break out the grinder and make it the way you need it! I have yet to get a single product from AMD that actually fit.

[bill440rt]

The goodmark one ait bad ,but I think its missing the two ears that weld to the rear crossmember, between the rear bumperettes.

I used one. Yep, the lower ears are missing so you'll either have to fab some or re-use your old ones if they still exist.
Fit wasn't all that bad, however the bumper holes don't line up so you have to enlarge them a bit. All of this repro metal out there needs some massaging to fit properly.
Good luck! 

[Ryan]

The goodmark one ait bad ,but I think its missing the two ears that weld to the rear crossmember, between the rear bumperettes.

I used one. Yep, the lower ears are missing so you'll either have to fab some or re-use your old ones if they still exist.
Fit wasn't all that bad, however the bumper holes don't line up so you have to enlarge them a bit. All of this repro metal out there needs some massaging to fit properly.
Good luck! 

Does it fit better than this at the valence corners?

[Silver R/T]

I've installed one on my 68 and fit was pretty good.

[Ryan]

I've installed one on my 68 and fit was pretty good.

Thanks. That looks good. I think I'll go ahead and purchase one. Hopefully between the goodmark and the AMD piece I'll be able to make a good valance.