Daytone rear window plug install

[6pkrtse]

I asked on another post but figured I would post on of my own to get the correct answers. For all you guys that have done them. I just picked up the Vega rear window hatch assy for mine. Does anyone have dimensions or a schematic on how you located where to center the rear window to be correct?

[richRTSE]

this is a pretty common question here, tons of answers if you search "vega hatch"...

this one might help you...quite a few other links referenced there too

http://www.dodgecharger.com/forum/index.php/topic,63115.0.html

[xx29440charger]

This is the info I have so far...
1. Alter the rear trunk deck lid 1st
I believe the measurements are from rear of the deck lid to front edge is 21 5/8 inches for the right and left side and the center rear to front is 21.5 inches. The front of the deck lid has a curve.
2. I have read that some people use the AMD 3rd generation dutchman panel
 3.A trunk closeout panel will also be needed.
4. Charger 500 or Daytona trunk hinges and mounts will be needed.
For plug....
1. Get 74-77 vega hatch
2. Remove trim
3. Remove glass
4. Remove inside steel from hatch
......this is the info I have so far ....I hope it can be of some help.....now I need further instructions....Thanks!
Thanks everybody for all your help so far....I could not do this project without you..I have the wing installed and already people are going ape shit over it....can't drive the car 2 blocks without looks.  I can't wait to see the peoples reaction when the entire car is finished.