Trans cooler line clips

[Paul 500]

Where does this trans line clip go, i know one goes on the starter motor stud but i dont know where the other one goes.
Thanks

[RD]

i believe it goes on the drivers side 9/16" timing cover bolt at the bottom.  I think of course, but not totally sure.

[y3chargerrt]

It goes on the bottom most bellhousing bolt on the driverside I believe.Been a while since I have been under there.

[Just 6T9 CHGR]

I believe there is only one....mounted on the lower bellhousing bolt like Y3 stated

[RD]

they are both correct, but honestly, i remember tearing apart an engine that had one on the timing cover bolt, but I believe it was a mid-70's motor, so they could be different.  good question, hope some others chime in to lay truth to this mystery.