Seat Belt configuration - need help

[70 Charger RT]

When I took the seat belts out of my 70 to get ready for the restoration, I never marked where each belt was located.  I need your help.  I downloaded a picture from PG Classics and numbered each belt so it would be easier to describe where each belt should go.  Here's what I can figure so far.
1 / 2 for front bucket outer
5 / 6 attach to roof and come across driver and passenger front
10 / 11 attach to floor behind driver and passenger and connect to 1 / 2 and 5 / 6
2 / 3 / 4 are for rear seat and connect to 7 / 8 / 9

Is that right?

Your thoughts.

[tan top]

    1 - 5- 6 -10 -11    are front belts  

1 are front outer retractors  -
5 & 6 are the roof shoulder belts -
10 & 11 go either side of the transmision tunnel / bolting through the floor !

   
   2 - 3 - 4 - 7 - 8 - 9  rear  

(( although , not affecting the belt order i have mentioned !!  they could have their pictures mixed up , as belts  2-3-4 look longer than the originals from memory  

order as they go  well for a 69 , prolly same for a 70

passenger side ------------------------ driver side

   2 - 7 - 3             trans tunnel             8 - 9 - 4


belts 7 & 3        use same bolt   on passenger side        as does  8 & 9 on driver side

[70 Charger RT]

Thanks Tantop

[70 Charger RT]

Has anyone purchased this kit from PG Classics?  What are your thoughts?  Is it worth it?