What do you guys use to hold down vacuum lines on firewall?

[sixpack_sid]

I'm running the wires on my 68 Charger. Getting her ready to start for the 1st time! What clamps should I use to hold down the vacuum lines & headlight harness running along the driver's side? Any pics would be helpful!
Thanks!

[Just 6T9 CHGR]

The clips are 1" or-so long T-shaped pieces that are about 1/4" wide to accept a piece of electrical tape on either side of the stud that goes into the inner fender...the tape wraps around the hoses to retain the clip....looking for a pic.

The headlight harness runs along the side of the fenderwell retained with plastic u-clips...

[Just 6T9 CHGR]

Almost looks like this (and probably would work...)

http://www.rtspecialties.net/proddetail.asp?prod=6015288

[tan top]

 took some pictures earlier  of mine  ,  but look like Chris has got it covered 
  but these might be of help too for reference !  

[tan top]

 

[sixpack_sid]

Thanks for the help! I would have never thought it went like that.

[twodko]

There are also some opaque plastic straps that are used in conjunction with the "T" thingys. These are also used to hold the washer bottle hose in place. I have 4 of the plastic straps, do you want them? Lemme know.

[sixpack_sid]

There are also some opaque plastic straps that are used in conjunction with the "T" thingys. These are also used to hold the washer bottle hose in place. I have 4 of the plastic straps, do you want them? Lemme know.

Sorry it took so long to reply. I got stuck on problems with painting the front grille. (as you know...).
Ok, how much do you want for them?

[twodko]

Zip. Send me an address and I'll drop 'em in the mail.