Question regarding using a ezwire harness and or MSD box

[moparguy01]

If any of you might know the answer to this, I bought the ez wiring 21 circuit harness to put in my charger. The question I'm not finding an answer to is that because I am also running a MSD 6al box, What components I can remove from the firewall? I'm thinking it will not need anything past the ballast resistor but I'm not having the best luck finding an answer. Anybody know? If I'm looking at the schematics right the MSD box will take the place of all of that stuff.

any help would be appreciated fellas!

Russ

[J-440]

  I too am running an MSD 6AL and you will not need the ballast resistor.

[Chryco Psycho]

you need to tie the start & run wire into the MSD switched circuit , nothing else is needed , no ballast , no coil feed wires as the coil is fed from the MSD