hughes rocker hold down stud kit with edelbrock heads..

[FLG]

Hey guys,

I've got the hughes rocker arm stud hold down for my eddy rpms and in the instructions it says "on all big block edelbrock heads, you must use the studs provided with the heads for the #2 and 4 positions" basically the "longer" ones...but since I bought these second hand I don't have these studs nor have I seen talk of them...why can't I use the studs provided in the kit? And if I can't where can I get em?

Thanks!

[FLG]

Found it in the instruction...so they are required, now i just need a PN or some help from eddy or hughes

"1) Rocker shaft hold-down studs, nuts and
washers for 2 places marked (S) in each head are supplied in this kit.
2) Double nut both studs and screw them in until they reach the bottom.
Install rocker shaft, factory concave washer and hard washer supplied
with this kit."

[FLG]

For future reference

Stud

http://www.summitracing.com/parts/ARP-AJ3-250-1B/

Washer

http://www.summitracing.com/parts/ARP-AJW625M/

Nut

http://www.lambcomponents.com/hardware-12-point-nuts-c-6_28_48/3-8-arp-nut-p-149

I have NO idea what the difference is between the ones hughes gave me and these, but for a few bucks id rather be safe than sorry. These are the ARP PN's given to me by eddy.

[Wicked72]

thanks for that info! Ill be getting my heads possibly from eddy but I if my funds allow it Im going with a bare set of indys.