Where do these go

[el dub]

More parts I'm looking for info on. Where do the nuts in upper left go. They have a rubber O ring? inside. Do they hold the dash pad on, or is it smething in the window area? Thanks

http://imageshack.us/photo/my-images/856/dsc00001small.jpg/

[Ghoste]

They look like dash pad nuts to me but it's a while since I had one off.  Is it actually an O ring in them or is it just sort of a sticky filler (as if to hold the nut in place)?

[el dub]

 Well, their rubber, kind of flattened out. But there's things like the glove box and the other dash  parts that stick thru the dash, but I only have a few of the rubber type. Thanks.

http://imageshack.us/photo/my-images/696/dsc00002afk.jpg/

[oldcarnut]

I don't recall having seen those before but maybe a good place to check would be somewhere attached they seal out water from the firewall or an emblem thru the body panel 

[tan top]

They look like dash pad nuts to me but it's a while since I had one off.  Is it actually an O ring in them or is it just sort of a sticky filler (as if to hold the nut in place)?

I don't recall having seen those before but maybe a good place to check would be somewhere attached they seal out water from the firewall or an emblem thru the body panel  

 all the ones that attached name plates /  stainless  trim to the out side of the body from the inside  , had a butle filling or something like Ghoste says  , & or a larger flat rubber sealing washer thing , not one that is actually inside ,  although these do look familiar

although picture is of a 69 ,  68 tail panel trim will attach different , just look at whats needed & try to match up the nuts & as a tempory mesure
to see whats what , have found that some suppliers of the repoped nuts are not quite the same as the OEM ! but do the job !
there are lots of them nuts used in the dash , for lower dash pads vents etc etc even glove box hinge from memory ,

[el dub]

Tan Top, thanks again for the pic of the 69. I looked in an old year one catalog for these parts and am finding a few. Thanks again. You must have taken your charger apart yourself from the good info I'm getting from you.

[tan top]

Tan Top, thanks again for the pic of the 69. I looked in an old year one catalog for these parts and am finding a few. Thanks again. You must have taken your charger apart yourself from the good info I'm getting from you.

no probs glad to help  ,  

,think were all charger & mopar nuts on here & for me any excuse to talk ,look at charger stuff  

taken mine appart  , you could say that ,  taken most of it appart & put it back togeather , first few years after buying it !
 
then about 10 years back ! decided to  stripped it down to the last clip nut  bolt & then some     &  do a complete nut & bolt restoration / rebuild , only things i did not do my self was  put the tires on the wheels/ balance   &   re chrome the bumpers   no one else touches or works on my charger  
had my charger over 22 years  

[el dub]

This butyl you're talking about, is that something you buy in a tube? Does it make it harder to take off down the road, without problems? Makes sense about the leaking water  part. Thanks.
                                           LW

[twodko]

You can buy an assortment of speed nut sizes at most auto part stores. Also pickup a package of dumdum at your local auto body/paint store. Its grey or cream color stuff that's like thick putty. Press a ball of it into the bottom of the speed nuts. When you snug them down the dumdum seals out water very well. good luck.