Filling gaps in new floor.

[AmadeusCharger500]

Brand new floor didn't fit exact and has some quarter inch sized gaps between the cross frame rail piece. Im not sure seem sealer is enough to fill these.

[tan top]

have you got a picture ??

[AmadeusCharger500]

Sure thing

[AmadeusCharger500]

Trans hump

[tan top]

the trans hump is more or less the same as the factory !

have you finished the welding ??  looks like the floor pan needs  fitting closer to the frame rail ,  when your welding floors etc etc in if you cant get clamps & stuff in there or got big enough ones   , put a few self tapping screws in to pull the two parts together & or  press down near where you plug welding  with a hammer shaft or appropriate size screwdriver or something !  sometimes  you need  massarge these parts into place  ie  put a block of wood on the floorpan  above the frame rail & give a smack with a hammer & or trim here & there to make the pan sit lower !  hard to discribe from being behind a key board , need to look whole thing , easier  in real life  to see what it needs


** Ignore ** what i have said above if you have finished welding  ,  cant really do much now ,  could use a panel hammer to close the gap as best you can from the underside  & then pump sealer in there & finish with a brush   would clean all that factory undercoat off first it it were me  

[hemi-hampton]

I screw it down tight to the framerail &/or croossmember with many screws. Then weld the plug welds holes, then remove screws & weld screw holes. Fits tight this way. Did you screw it down tight?? Or did you forget this step?   LEON.