4 speed hump help

[poppa]

Does anyone,with a 69 4 speed, have their interior out that could take some pics and measurements of where the shifter hole should be, approximately. Now that my dash is in it seems too far forward. I was going to weld in the console brackets but I want to make sure it's at least pretty close. Thanks for your time.

[Charger-Bodie]

I don't have measurements, but these pic show pretty good reference.

[poppa]

Thank the future gearhead in the pics. They should help...

[Troy]

I can get measurements but how could the hole be located in the wrong spot??? The "hump" only fits one way.

Troy

[poppa]

Someone previously just hacked the crap out of my hump area ,so I just want to make sure it's in the ballpark before I weld my brackets in. It must have had a auto console in there at one time that someone cut off. The remains of the rear console bracket were still there and if I line up the rear bracket with that spot,it seems too far back.Thank you

[Troy]

The first two are my clone and the second two are my original 4-speed R/T. The tape measure was wedged into the seam between the firewall and floor pan.

Troy

[poppa]

Perfect. Thanks for taking the time to do that for me.