Carpet advice - would like to order one today!

[bobs66440]

For the seat stud/gas pedal holes I used an old PC board soldering iron and melted clean holes right through.

Oh man! Brilliant!  Excellent idea! That's how I'll do the seats. That will be much easier than using a drill bit! Thanks! 

[BananaDan]

 

I love the idea, and that's what I'll do.

Dan

[BIGBLCK11]

Did you receive the ACC carpet yet or get it installed?  I was wondering what you thought of it, before ordering mine. Thanks.

[BananaDan]

I did get it, and was planning on putting it in this weekend.  However this past weekend when I did my insulation install I realized that Elemental Designs only shipped me half of my insulation order, the v4 Teklite was on back-order and I didn't realize it because the box that came weighed so damn much I assumed it was all in there.  The remaining insulation arrives next week, so my carpet install is now pushed to next weekend, 4/16.  I'll let you all know how it goes then.

Dan

[BIGBLCK11]

Ok, I will keep my eyes peeled for an update.  How were the folds, if not still in the box?

[BananaDan]

Still in the box.  I know, I know, I'm supposed to have removed it right away, but my basement is loaded with boxes of parts right now and I don't have the room.  I'll unbox it and lay it out in my garage at least one week before I install.  I figure that should be good.

Dan