1971 dodge charger emblem placements

[71charger]

I have a 1971 charger base model, I was wondering where EVERY charger emblems are supposed to be at. Pictures would be cool.

[71charger_fan]

http://www.lov2xlr8.no/brochures/mopar/71dcha.html

http://www.lov2xlr8.no/brochures/dodge/71doc/71doc.html

[Nacho-RT74]

"Charger" a little bit over the middle body side height of fender
"Dodge" on grille
"Charger---Dodge division" on passenger side deck lid
Pentastar just on driver side fender below the lower body line.
Charger crest on bumper

Thats all for a basic model

Then "Charger" on dash, passenger side insert

[chargd72]

"Charger" a little bit over the middle body side height of fender
"Dodge" on grille
"Charger---Dodge division" on passenger side deck lid
Pentastar just on driver side fender below the lower body line.
Charger crest on bumper

Thats all for a basic model

Then "Charger" on dash, passenger side insert

Don't you mean passenger side?

[Nacho-RT74]

ooops, sorry, yes, passenger

[71charger]

OK all I'm missing is the 2 fender chargers and the pentastar.

[1972Rallye]

OK all I'm missing is the 2 fender chargers and the pentastar.

Send me a PM with your e-mail address and I'll send you copies of the engineering drawings for placement... They're hard to read, but will help a little. 

[1972Rallye]

I though I'd share this for all who may be interested...

Deck Lid placement-
See picture 

Fender placement-
Fore/Aft:
Charger with medallion: 2.5" approx to rear edge of fender (Base & SE)
Charger 500: 2.5" approx to rear edge of fender
Charger R/T: 2.0" approx to rear edge of fender
Charger Super Bee: 1.5" approx to rear edge of fender with 3/8" to 1/2" between emblem and bee decal

Up/Down:
In-line with side marker lights. With the side marker lights installed, tape a string from front to back with the string running through the center of the marker lights.  Make sure the string is tight (straight).  The string is now your reference line and should run right through the center of your emblems.  See pics for examples. My Bee sticker is too far from the emblem.  I didn't put it there so it stays.

Please note: These dimensions are taken from original Chrysler drawings.  How the guys on the line placed them may be different.  When possible, use your original locations for reference.  Otherwise this info should get them where they were intended to go.