B-body upper control arms

[lexxman]

Does any have a picture of the upper control arms without the bushings?I was removing the old bushings .but I'm not sure what is bushing and what is arm.

[bull]

Be sure to unscrew the ball joint. Don't pry or use a press, etc.

[bull]

Ooops, sorry. You wanted bushing area pics. Lemme see here... The flange is part of the bushing but there is a shoulder on the outsides of both holes that stick out about 3/8" or so. The bushing flange stops against that shoulder when you press it in.

[lexxman]

Yes I did unscrew them.This helps,the bushings are so rusted its hard to see.I will be takeing them to work to clean them up.

[pipeliner]

Be sure to unscrew the ball joint. Don't pry or use a press, etc.

or knock it out with a sledge hammer like I did for the first time 

[bull]

Be sure to unscrew the ball joint. Don't pry or use a press, etc.

or knock it out with a sledge hammer like I did for the first time 

That's when you're doing the single-use method In that case it's easier and less time consuming to just pitch them in the scrap heap.

Yes I did unscrew them.This helps,the bushings are so rusted its hard to see.I will be takeing them to work to clean them up.

I used a bolt to push the old ones out with a press but the hard part was going trhough the opposite side to get to them. I believe one of them came apart from the inside out and I had to use a hack saw and grinder on the outer bushing sleeve to get it out. Nothing can be easy.