HEMI Emblem question

[troy.70R/T]

I was wondering if anyone with a hemi Charger would measure the HEMI emblem that is on the door for me. I need the length, wide and thickness on it. I would also like to Know the height and width of the letter "H" on the emblem. I am a machinist and I want these measurements so I can make me a set out of Stainless steel  that say 440 on them. I would also appreciate some close up pictures as well.  Thanks also if anyone would be interested in a set let me know.

[FLG]

Hmm, cant tell ya the dimensions but depending on how they come out i might want a set  (not sure where id put em)

[troy.70R/T]

Well just so you know this is a futuer project might take me 6 months to actually get some done.

[UFO]

Overall W 130mm- H 29mm.
Raised area W 124mm- H 21mm.
"H" H 11mm- W 22mm.
Not flat it's beveled from 5mm at the top to 8mm.
Raised area is only 1mm.

[troy.70R/T]

Thanks for the measurements and pictures UFO. I thought they had that little edge around the emblem but was not sure.