73 Charger door / window questions

[64dartgt]

I have a 73 Charger, base model.  The drivers door was replaced at some point and there is a gap of about a half inch between the door glass and quarter glass.  I am thinking that perhaps the door glass for the SE might have had slightly different dimensions, but can't confirm.  Anyone know?

[Nacho-RT74]

same door glases in all 71/74 Charger all models.

only diff glasses between 3rd gens are quarter, being 71, then 72 and then 73/74, talking at least between roll down windows.

71/72s being interchangeable as complete assembly, not just the glass

[64dartgt]

That is good news.  My windows are power, but perhaps one of the windows is just a bit out of kilter somehow.  Thanks.

[RallyeMike]

If the windows go all the way up, my guess is that you are missing the rubber seal that fit between the front and rear glass. It is usually attached to the rear window chrome on the leading edge.

[64dartgt]

There is a rubber seal there and both windows go to the top.  The seal matches the other side, which seals fine. The only obvious issue is that the door window isn't going down all the way, but it is likely due to a minor issue after a window motor replacement.

[Nacho-RT74]

rear glast must be adjusted to meet with front, once front is totally aligned and sealed with roof rail weatherstrip... all around including of course with pillar.

and this must be AFTER you are sure the door is aligned with body, al around too